Re: [ts-7000] Any tricks to get serial port 3 to work on a 7260

[Dave Cramer <>]

Michael,

What I do see when pppd starts up is 

tsuart:change_speed, port 0: 115200 bad

I don't see that with the other two ports.

Dave

On 4-Jun-08, at 8:42 PM, Michael Schmidt wrote:

Dave Cramer wrote:
> I have pppd working on the other two ports. It just won't work on this port

Hmm, that's very odd. I'm not too familiar with the low-level details 
of pppd to suggest anything that might be wrong, but I would suggest 
looking at which might be different between the ports that are working 
and the port that isn't. For example, the TS-UART port won't have some 
of the flow control signals the 16550 UART will, and won't have the FIFO 
depth either. You might need to play around with pppd parameters to 
accomodate these differences. Any you getting any log or error messages 
that might be helpful or does it just silently fail? (I believe there 
are also pppd options to be more verbose in log g ing what it is doing.)

> Dave

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___