ts-7000
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

Re: [ts-7000] Any tricks to get serial port 3 to work on a 7260

from [Dave Cramer] [Permanent Link][Original]
To:
Subject: Re: [ts-7000] Any tricks to get serial port 3 to work on a 7260
From: Dave Cramer <>
Date: Fri, 6 Jun 2008 18:51:04 -0400
Hmm...


OK, I"ll keep trying.

Dave
On 5-Jun-08, at 12:30 PM, Michael Schmidt wrote:

Triffid Hunter wrote:
> On Wed, 4 Jun 2008, Dave Cramer wrote:
> 
>> Michael,
>>
>> What I do see when pppd starts up is
>>
>> tsuart:change_speed, port 0: 115200 bad
>>
>> I don't see that with the other two ports.
> 
> Perhaps it only goes to 57600?

No, there is a typo in the message. It should say "baud" not "bad".

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael


__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [ts-7000] Passthrough route between eth2 and eth0, Fred
Next by Date:  [ts-7000] gps + gsm modem pc104 card cheap, Dave Cramer
Previous by Thread:  Re: [ts-7000] Any tricks to get serial port 3 to work on a 7260, Michael Schmidt
Next by Thread:  [ts-7000] Curiosity with PL2303 and getty., naturalwatt
Indexes:  [Date] [Thread] [Top] [All Lists]
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU