Re: [ts-7000] Any tricks to get serial port 3 to work on a 7260

[Michael Schmidt <>]

Triffid Hunter wrote:
> On Wed, 4 Jun 2008, Dave Cramer wrote:
> 
>> Michael,
>>
>> What I do see when pppd starts up is
>>
>> tsuart:change_speed, port 0: 115200 bad
>>
>> I don't see that with the other two ports.
> 
> Perhaps it only goes to 57600?

No, there is a typo in the message. It should say "baud" not "bad".


  ______   Best Regards,
|__  __/                  Michael Schmidt
    ||                   Software Engineer
    ||echnologic Systems (EmbeddedARM.com)
    || (480)    16610 East Laser Drive #10
    |/ 837-5200   Fountain Hills, AZ 85268
        http://oz.embeddedarm.com/~michael

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/