j.chitte wrote:
> --- In
m("yahoogroups.com","ts-7000");">.com, pierre lafrance <pierrotlafouine@
...>
> wrote:
>>
>> Hi
>> I have done dd image file to FLASH,
>> expand partition 3 with ext2resize,
>> check summed first 100bytes of image file on disk and on FLASH,
>> all was successful
>>
>> Then I boot TS-7300 with this FLASH.
>> Fastboot was done correctly,
>> I wrote exit, then nothing happen (board freeze as usual)
>>
>> Once, I cycled power of the board a second time, then made ls
> command after fastboot.
>> ls displayed files correctly
>> then I wrote exit, TS-7300 started boot correctly...!!!
>>
>> It looked to me the delay between fastboot is done and when I write
> exit is important.
>> To verify that, I removed jumper J6, cycle power, board freeze...
>>
>> Put back jumper J6, cycle power, wait 1minutes after fastboot was
> done, and wrote exit, board booted correctly...
>> Got the same behavior with a second FLASH card...!!!
>> What the hell is going on with this board ?
>>
>> Pierre
>>
>
> OK. that's considerable progress in terms of know where you are. Now
> you have a clearer idea of what is going on , have you contacted TS?
>
> Since it's all pretty much std TS with a flash on the image they
> provide, it seems you have a legitimate support issue.
>
> /js
Are you using the latest SD card image from the ftp site? There was a
problem with a race condition a while back, but as far as I know it was
fixed so the latest images should not have this problem. If you still
see the problem after downloading the latest image please let me know
and I will forward the info to the engineer who found the previous fix.
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16525 East Laser Drive
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
Win a trip with your 3 best buddies.