Thanks for taking the time to help out a newcomer. Very impressed with the =
work from the members of this list. I can't wait to give it a whirl.
Andy
--- In Rob Danielson <> wrote:
>
>
>
> Hi Andy--
>
> I replied to your earlier question but it appears to have not gotten thro=
ugh.
>
> I would go ahead and get the Art Phantom II to be stereo-ready.
>
>
>
> To run one mic, connect a single NT1-A to the=C2=A0channel 1 input of the=
Art Phantom II and=C2=A0make-up a cable like=C2=A0below that=C2=A0connects=
beween the=C2=A0Channel 1=C2=A0output of the Art Phantom II=C2=A0and the 3=
.5mm input of your recorder:
>
>
>
> On the XLR end, "tie" pin #1 and pin #3=C2=A0by soldering a short=C2=A0ju=
mper cable between them. Connect #1 to the shield (woven, outside=C2=A0wire=
s) of a ~18" length of=C2=A0mic cable.=C2=A0=C2=A0Connect Pin #2 to one of =
the interior leads=C2=A0of the 18" mic cable-- be sure to note the color.
>
>
>
> On the 3.5 mm end of this cable, connect the shield to the sleeve . Conne=
ct the interior lead from #2 to both the Tip and Ring of the 3.5mm stereo m=
ale plug for the mic input. This will deliver the signal from the=C2=A0NT1-=
A to both channels. Rob D.
>
>
>
>
>
>
> From: "ourobouros2k2" <>
> To:
> Sent: Sunday, July 4, 2010 3:21:52 PM
> Subject: [Nature Recordists] Re: New here, with question about phantom po=
wer rigs
>
> =C2=A0
>
>
>
>
>
>
> I was wondering if the following would be a feasible 1 mic solution..
> NT1A
> Art phantom 3 single channel phantom power box...
> Samson S-Split
> adapter cable
> M10 recorder....
>
> If that was feasible I could hit the ground running in a short time. I co=
uld always add another mic and upgrade to dual channel phantom power later =
on...
>
> thanks
> Andy
>
>
>
>
>
|