That type of configuration might have to do until I can afford a stereo rig=
...
pardon my ignorance but I am curious if the dynamics of this setup will wor=
k:
Rode nt1a's into the art phantom 2, output to adapter cable (like you menti=
oned in the faq) and then straight into the PIP (Pink jack 1/8") of the M10=
? Does PIP option need to be on or off in the menu? I certainly don't want =
to fry any inputs in the recorder lol and am very new at this.
A friend of mine told me that since the xlr outputs of the art phantom 2 ar=
e balanced, that it would not be compatible with the recorder without match=
ing impedance, so is there another addition to the chain that I am leaving =
out?
Thanks for bearing with my questions..
Andy
--- In Rob Danielson <> wrote:
>
>
>
> Hi Andy--
>
> I believe one can use just one channel of the Art PII with a temporary ca=
ble:=C3=82=C2=A0=C3=82=C2=A0Connect NT1-A to Channel 1. In the wiring of th=
e XLR connector to the Art Phamtom II=C3=82=C2=A0Ch1's output,=C3=82=C2=A0s=
older a jumper lead from=C3=82=C2=A0pin #1 (ground) to Pin #3 (Signal Low).=
=C3=82=C2=A0Pin #2 goes to the Tip and the Ring of the 3.5mm Mic PLug and=
=C3=82=C2=A0the ground from the XLR=C3=82=C2=A0goes to the sleeve (ground)=
=C3=82=C2=A0on the 3.5mm plug=C3=82=C2=A0. This should=C3=82=C2=A0send=C3=
=82=C2=A0the mic to Left and Right inputs of the M10. Rob D.
>
>
>
>
>
>
> From: "ourobouros2k2" <>
> To:
> Sent: Friday, July 2, 2010 11:23:52 PM
> Subject: [Nature Recordists] Re: New here, with question about phantom po=
wer rigs
>
> =C3=82=C2=A0
>
>
>
>
>
> Thanks! I was looking at one that was 169.00 in canada, but am glad I fou=
nd the ART Phantom 2. My plan is to used a matched pair of Rode nt1a's. Gon=
na be a bit till my cash flow matches my plan though...I was going to try o=
ne and do a mono recording, but it doesn't look like the PCM-M10 can do tha=
t. All external mic references in the manual call for a stereo mic, so I wi=
ll just have to wait..
>
> Andy
>
>
>
>
>
|