OK, it seems there is something wrong with irq=22. If the jumpers are set for
other irqs (33 or 40), the interface comes up fine.
Don
--- In "Rekcut_Nod" <> wrote:
>
> For the record, I was able to figure out how to load the drivers with Brett's
> help at Technologic Systems:
>
> modprobe -o tseth2-1 ax88796b mem=0x200 irq=22
> modprobe -o tseth2-2 ax88796b mem=0x240 irq=33
>
> Now the interfaces from the TS-ETH2 show up when I type "ifconfig -a", but
> when I actually try to bring the interfaces up I get an error:
>
> ts7000:/root/ifconfig eth1 up
> eth1: Unable to get IRQ 22 (errno=-22).
> SIOCSIFFLAGS: No such device or address.
>
> Has anyone had any luck using the TS-ETH2 with a 2.6 kernel?
>
> Don
> --- In Don Tucker <dtucker@> wrote:
> >
> > Kris, I tried adding the iobase parameter to the insmod command, but the
> > result was the same.
> >
> > insmod ts-dual-eth1.ko iobase=0x11e00000 mem=0x200 irq=22
> > AX88796B: not found (no reset ack)
> > insmod: error inserting 'ts-dual-eth1.ko': -1 No such device or address
> >
> > Is that the correct syntax?
> >
> > Don
> > On 1/26/2011 2:05 PM, Kris wrote:
> > >
> > > You also need to specify the iobase parameter, this is the base of the
> > > PC/104 address region.
> > >
> > > -Kris Bahnsen
> > > Technologic Systems
> > >
> > > --- In <ts-7000%40yahoogroups.com>, Don
> > > Tucker <dtucker@> wrote:
> > > >
> > > > The getting started page for the TS-ETH2
> > > > http://www.embeddedarm.com/about/resource.php?item=365
> > > > explains how to load modules for the 2.4 kernel, but not for the 2.6
> > > kernel.
> > > >
> > > > I tried to follow the analogous procedure:
> > > >
> > > > modprobe libcrc32c
> > > > cp ax887696b.ko ts-dual-eth1.ko
> > > > insmod ts-dual-eth1.ko mem=0x100 irq=22
> > > >
> > > > But, this returns an error:
> > > >
> > > > AX88796B: not found (no reset ack)
> > > > insmod: error inserting 'ts-dual-eth1.ko': -1 No such device or address
> > > >
> > > >
> > > > Is there a procedure for using the TS-ETH2 with a 2.6 kernel?
> > > >
> > > > Thanks,
> > > > Don
> > > >
> > >
> > >
> >
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|