Hi Zhaomin,
> Thank you very much for your kindness, Dave!
> The CMOS sensor I use is OV9630. I interface the 8-bit pixel data
> (bayer format) to DIO0-DIO7, HREF signal (high means one line) to
> DIO8, VSYNC signal (low means one frame) to DIO9 and PCLK (one cycle
> means one pixel) to DIO15. The CMOS sensor clck frequency is 24Mhz (it
> can be reduced to 12Mhz, 6Mhz... however).
> Just now I rechecked the ts7300-opencore source code, and find that
> 0x72a00000 to 0x72fffffc can be freely programed. The space is large
> enough to save a full frame (1280*1024).
> I'd like to keep TS-VIDCORE since I want to output image to a LCD display.
> The datasheet of ov9630 will be sent to your email address in a minute.
Ok, when I receive it, I'll take a look and tell you how
I would implement it. Then you can take a shot at it,
and if you have trouble I'll help out.
Do you have the web editions of the Altera Quartus tool and
ModelSim installed? Or do you have fully versions?
https://www.altera.com/support/software/download/altera_design/quartus_we/dnl-quartus_we.jsp
http://www.altera.com/products/software/products/model/eda-ms.html
Cheers
Dave
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|