--- In Jim Jackson <> wrote:
>
>
>
>
> On Mon, 21 Aug 2006, weide72 wrote:
>
> > Hi-
> >
> > Just wondering what the correct connection would be to connect a DB-9
> > Male connector to the COM2 port on the TS-7260? Jim Jackson's link on
> > this group's links page differs from the TS-7260 manual. All I need
> > to connect is TX, RX, and GND. Thanks.
> >
> > Ryan
> >
>
> If the ts7260 manual is the same in this area as the ts7200 manual, then
> the answer is that both TS and myself are correct :-)
>
> It depends on how you number the pins. My page uses a more standard pin
> numbering, the Technologics manual uses a non-standard numbering.
> So be carefull and follow the manual, but make sure you understand which
> they call pin 1 etc
>
Yes, they do this to match the 10-pins connector with the
corresponding DB9 pins.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|