--- In "asc135" <> wrote:
>
> --- In "weide72" <weide72@> wrote:
> >
> > Hi-
> >
> > Just wondering what the correct connection would be to connect a
DB-9
> > Male connector to the COM2 port on the TS-7260? Jim Jackson's
link on
> > this group's links page differs from the TS-7260 manual. All I
need
> > to connect is TX, RX, and GND. Thanks.
> >
> > Ryan
> >
>
> The serial ports on the TS-7260 conform to the same pinout as the
> serial port on an IBM compatible computer. It is a DTE
configuration:
>
> pin 2 = RX
> pin 3 = TX
> pin 5 = GND
>
> The same cable you used when operating your peripheral device from a
> PC can be used with the TS-7260 COM2 port.
>
Sorry... I initially misunderstood your message. My development 7260
is in a TS housing with the COM ports brought out to a panel of DE-9M
connectors so I thought you were asking how to connect to those, not
the header on the board. I would recommend the TS premanufactured
header to D-sub cable assembly. The price is very reasonable and the
pinout is, of course, correct.
Incidentally, and I realize this is a lost cause, referring to the
connector as "DB-9" is for computer store salesmen and their equally
unsophisticated MS-IE-using customer base. You are a savvy embedded
ARM user and should use the correct term! :)
http://en.wikipedia.org/wiki/DE-9_connector
http://en.wikipedia.org/wiki/D-subminiature
http://www.answers.com/topic/de-9-connector
Regards,
Amardeep
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|