| To: | |
|---|---|
| Subject: | Re: [ts-7000] COM2 Pinouts |
| From: | Jim Jackson <> |
| Date: | Wed, 23 Aug 2006 12:49:23 +0100 (BST) |
On Mon, 21 Aug 2006, weide72 wrote:
> Hi-
>
> Just wondering what the correct connection would be to connect a DB-9
> Male connector to the COM2 port on the TS-7260? Jim Jackson's link on
> this group's links page differs from the TS-7260 manual. All I need
> to connect is TX, RX, and GND. Thanks.
>
> Ryan
>
If the ts7260 manual is the same in this area as the ts7200 manual, then
the answer is that both TS and myself are correct :-)
It depends on how you number the pins. My page uses a more standard pin
numbering, the Technologics manual uses a non-standard numbering.
So be carefull and follow the manual, but make sure you understand which
they call pin 1 etc
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [ts-7000] Re: TS 7260 & C#, stageelectronique |
|---|---|
| Next by Date: | [ts-7000] Re: TS 7260 & C or C++, Matt Godbolt |
| Previous by Thread: | [ts-7000] COM2 Pinouts, weide72 |
| Next by Thread: | [ts-7000] Re: COM2 Pinouts, mathlaj |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU