| Subject: | Re: dynamic microphones |
|---|---|
| From: | "Dan Dugan" dandugan_1999 |
| Date: | Thu Mar 8, 2007 2:21 pm ((PST)) |
> >dBV/Pa Open Circuit mV >>-60 1.0 >>-50 3.2 (hot dynamic mic) >>-40 10.0 (condensor mic) >> 0 1000.0 (1 Volt) > >The rule of thumb I've come across in a few >places is 10mV/Pa being a reference minimum in >sensitivity for condenser mics if one is after >lower noise performance. Does this correspond >with your -40 dBV/Pa, Dan? Exactly. -Dan Dugan |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Connector, cables, attenuation, stoatwizard |
|---|---|
| Next by Date: | Re: dynamic microphones, Dan Dugan |
| Previous by Thread: | Re: dynamic microphones, Rob Danielson |
| Next by Thread: | Re: dynamic microphones, Dan Dugan |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU