I honestly wonder if the board is capable of passing enough power to
the HDD to run. I'd connect a larger PS to the board, if you have a 5
or 10 amp variable bench supply handy that would work.
Jason
os2hoppy wrote:
When I boot the TS-7260 alone everything works fine. When I connect
the TS-9600 to the PC/104 interface the device boots up fine as well.
However when I attach an IDE HDD to the device it cycles through the
following (ie it never gets to the "+" where there seems to be
normally a pause that signals the boot to TS-Linux):
TS-NANDBOOT, Rev 1.01 - built 10:30:52, Dec 20 2005
Copyright (C) 2005, Technologic Systems
TS-BOOTROM, Rev 1.08 - built 10:40:29, Jun 12 2006
Copyright (C) 2006, Technologic Systems
TS-7260: Rev >E1 CPU, Rev E PLD, 64MB SDRAM, options ( SDCARD )
Found FIS directory at 07fe0000
And then it restarts that same text without stop.
This happens even if I have selected IRQ 14 / 7 with the switch.
The device is set up with an enclosure sold by embeddedarm, and the
adapter is the one from their website as well. I have not added any
parts from any other supplier.
Any ideas of the cause of this ? I should be passing enough power to
the setup (7260 + 9600 + WD 2.5" HDD).
Thanks
Sean
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
m("yahoogroups.com","ts-7000-digest");">
m("yahoogroups.com","ts-7000-fullfeatured");">
<*> To unsubscribe from this group, send an email to:
m("yahoogroups.com","ts-7000-unsubscribe");">
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
__._,_.___
![]()
SPONSORED LINKS
__,_._,___
|
|