Re: [ts-7000] Re: Opinions on product?

["Dustin Oprea" <>]

 

I wouldn't expect a response from Technologic in under a week.. You can post questions here, though, and the occasional Tech. employee will respond in addition to the usual members.

 

I have been developing software that implements the CAN bus for the automotive industry, and have been so impressed with the amount of fault-tolerance and flexibility inherent in the devices. Plus, it seems that the technology is very open and well-discussed.
 

 

Dustin Oprea

 

On 11/30/07, PeterElliot <> wrote:

--- In ts-7000%40yahoogroups.com, "Charlie Wallace" <> wrote:
>
> Will the TS-BAT3 work with enclosure, should i get it instead? Its
for an
> automotive application so controlled shutdown/startup is something
to
> consider.
>

I use a TS-7300 with the enclosure and a TS-BAT3 board. You simply
move the 5V power out from the enclosure PSU PCV to the BAT3 5V input
connector and ignore the 12/24V input.

I added an 800x600 10.4" serial touch LCD (custom version of the
NagasakiIPC LM-104T), and a custom PCB connected to the FPGA header.

I've not used the CAN port as I repurposed the pin for my encoder
board.

With regard to Technologic Systems, I've had very positive dealings
with them. I would think they're very busy at the moment getting the
TS-7800 out the door.

Hope this helps,

PJE

-- 

Dustin Oprea

Software Engineer
Intrepid Control Systems
(1+) 248-726-0605 

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___