--- In Randy Hunsaker <> wrote:
>
> Jeff,
>
> I had the same problem with a TS-7260 board. It actually wasn't the
board at all - it was the fact that I had flow control turned on in
Hyper Terminal. According to TS, you must turn off all flow control
on the RS-232 connection you are using to monitor the console port.
Once I truned this off, I could use Ctrl-C to interrupt RedBoot.
>
> Good luck,
> Randy
Thanks. That was it: I had hardware flow control turned on. Now I can
interrupt Redboot.
But I can't get it to load hda1:/boot/vmlinuz. I tried this command
(which wasn't in the manual but I found in this list somewhere):
RedBoot> load -r -b 0x00218000 -m disk hda1:/boot/vmlinuz
e2fs_open: e2fs_inode_lookup failed
Can't load 'hda1:/boot/vmlinuz': Can't open file
Its there, at least the "disks" command shows both hda1 and Linux.
Did I not get the load command right?
Regards,
Jeff
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|