Hello,
> You were both right; I forgot to remove the jumper. :)
> Next issue;
> Some modules don't seem to load anymore on start-up (e.g. usb
> modules). I've added them to the rcS.sysinit file in the right order,
> but despite the fact that module zdb.o is loaded now, the start-up
> process fails to initialize wlan0. (SIOCGIFINDEX failed!: no such
> device).
This implies the interface has not been created yet. You'll probably
want to add a delay until the interface is created prior to trying to
configure the network interface...
--
Best Regards,
______________________________________________________________
Eddie Dawydiuk, Technologic Systems | voice: (480) 837-5200
16610 East Laser Drive Suite 10 | fax: (480) 837-5300
Fountain Hills, AZ 85268 | web: www.embeddedARM.com
> --- In "Loren M. Lang" <> wrote:
>>
>> oj199933 wrote:
>>>
>>>
>>> Hello,
>>>
>>> I'm trying to bypass the fastboot console of my TS-7400 in order to
>>> load the kernel autmatically from flash.
>>> According to the manual I should use the following command:
>>> "ln -sf /linuxrc-mtdroot /linuxrc; save"
>>>
>>> I've excuted this command at the fastboot prompt, and used cat to
>>> check if the linuxrc file is configured correctly. This went right,
>>> but after a reboot the linuxrc file has been reset to its old value
>>> (fastboot).
>>> (I've already removed the "/fastboot" file.)
>>
>> Did you remove the jumper for multi-user mode? Once I removed it from
>> my TS-7300, it booted into full multi-user mode with root mounted
>> read-write, though my system no longer booted in 1.23 seconds.
>>
>>>
>>> What went wrong?
>>>
>>> Thanks in advance.
>>>
>>>
>>
>>
>> --
>> Loren M. Lang
>>
>> http://www.north-winds.org/
>>
>>
>> Public Key: ftp://ftp.north-winds.org/pub/lorenl_pubkey.asc
>> Fingerprint: CEE1 AAE2 F66C 59B5 34CA C415 6D35 E847 0118 A3D2
>>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|