Hello,
> I'm trying to bypass the fastboot console of my TS-7400 in order to
> load the kernel autmatically from flash.
> According to the manual I should use the following command:
> "ln -sf /linuxrc-mtdroot /linuxrc; save"
>
> I've excuted this command at the fastboot prompt, and used cat to
> check if the linuxrc file is configured correctly. This went right,
> but after a reboot the linuxrc file has been reset to its old value
> (fastboot).
> (I've already removed the "/fastboot" file.)
>
> What went wrong?
Please ensure you don't have the boot jumper on the TS-9441. If you have
the boot jumper on and the write enable jumper off you would see this
behavior.
--
Best Regards,
______________________________________________________________
Eddie Dawydiuk, Technologic Systems | voice: (480) 837-5200
16610 East Laser Drive Suite 10 | fax: (480) 837-5300
Fountain Hills, AZ 85268 | web: www.embeddedARM.com
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|