I haven't run across many NIC's that can auto negotiate that aren't
gigabit... What do you use?
Jason
Don W. Carr wrote:
By dummy he means looping back some of the control signals
to make a system that hardware handshaking is working, like looping
back request to send to clear to send. Cables like that will work, but
no need. Make sure you turn off hardware handshaking in your terminal
program.
Also, almost all modern ethernet ports can detect that the tx and rx
are crossed and adjust. I have only used normal off the shelf ethernet
cables. Don't mess with ethernet crossover cables.
Don.
On 1/29/07, Alvaro Aguirre <>
wrote:
I only can spec about what is a dummy and full handshaking
cables but you only need a cable without handshaking (but anyone will
do the job for the TS)
On 1/29/07,
HOSAM YOUSIF <>
wrote:
there are 3 types of serial i want to know who i will use:
1.without handshaking
2.dummy handshaking
3.full handshaking
--- In ts-7000%40yahoogroups.com,
Per Ãberg m("...","oberg");"><> wrote:
>
> Hi
>
> > 1. the type of serial cable between my pc and ts-7250 is
crossover or
> > straight.
>
> Crossover
>
> > 2. the type of ethernet cable between my pc and ts-7250 is
crossover
> > or straight.
>
> Crossover
>
> > 3. i have power supply it's output is 5v and 2A this power
sufficient
> > or my board will in danger.
>
> I have 2A and I have no problems. I will not promise anything but i
> doubt that having to weak PS will damage your TS-board. If
anything, it
> might damage your supply.
>
> //Per Ãberg
>
>
> --
> Per Ãberg, Ph.D. Student
> Address: Division of Vehicular Systems
> Department of Electrical Engineering
> LinkÃpings universitet
> 581 83 LinkÃping, SWEDEN
> Phone: +46 (0)13-28 23 69
> e-mail:
>
--
Dr. Don W. Carr
J. G. Montenegro 2258
Guadalajara, Mexico
+52-333-630-0704
+52-333-836-4500 ext 2930
__._,_.___
![]()
__,_._,___
|
|