I was looking at the TS-7300 picture. Your technician does a nice job.
Out of curiosity, did he use a solder mask for this board? or solder paste
directly?
Was the board reflowed? or did he use a soldering iron, or hotair rework
station?
Cause it looks like a production job?
-Curtis.
On March 2, 2006 02:09 pm, Jesse Off wrote:
> All the pictures of our boards on our website are of prototype units
> that were hand built before we had full production set up (including
> the TS-7300 at http://www.embeddedarm.com/images/7300stcllw.jpg). Our
> technician down here is legendary in our
> office for his skill with a soldering iron. If you mention that you
> need some jumper wires soldered to the EP9302 JTAG pins when you order
> the board, I'm sure we could rework the board for a small fee.
>
> //Jesse Off
>
> > There is a posting in this news group where a skilled engineer
> brought out the
> > JTAG by soldering directly the the EP9302 pins on the controller.
> (It seems
> > pretty incredible this guy managed to solder these, seeing as the
> pins are
> > only ~0.20mm wide and ~0.30mm apart).
> >
> >
> > -Curtis.
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|
