naturerecordists
[Top] [All Lists]

Re: Creating delrin mic supports for SASS

Subject: Re: Creating delrin mic supports for SASS
From: "Paul Jacobson" thebrunswicktwitcher
Date: Sun Sep 26, 2010 1:47 pm ((PDT))
Hi Paul,

On 27/09/2010, at 6:40 AM, thesilverloon wrote:

> Hello Vicki,
> Can I ask where you sourced the foam for your nosepiece?
> The density that Rob suggests does not seem to be easily found. Most open=
 cell foams
> that I can find have a far higher density than what Rob recommends.
> I live in Sydney by the way.
>
> Paul


The only requirement of the foam is that it attenuates a minimum of 3dB per=
 inch above 1200hz.  This means higher density foam is perfectly acceptable=
, and I'm using a high density furnishing foam from Clark Rubber to good ef=
fect.

cheers
Paul





<Prev in Thread] Current Thread [Next in Thread>
Admin

The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU