Re: Creating delrin mic supports for SASS

["thesilverloon" thesilverloon]

Paul, thanks for that.
Are you able to show a photo of your setup?
If I go to Clark Rubber, which foam should I be asking for. They have heaps=
 to choose from.

Paul

--- In  Paul Jacobson <> wrote:
>
> Hi Paul,
>
> On 27/09/2010, at 6:40 AM, thesilverloon wrote:
>
> > Hello Vicki,
> > Can I ask where you sourced the foam for your nosepiece?
> > The density that Rob suggests does not seem to be easily found. Most op=
en cell foams
> > that I can find have a far higher density than what Rob recommends.
> > I live in Sydney by the way.
> >
> > Paul
>
>
> The only requirement of the foam is that it attenuates a minimum of 3dB p=
er inch above 1200hz.  This means higher density foam is perfectly acceptab=
le, and I'm using a high density furnishing foam from Clark Rubber to good =
effect.
>
> cheers
> Paul
>