Apologies for not realizing this and asking sooner, but for MY purposes, is
there any advantage to purchasing the NT1-A in a matched pair, or will just
buying a couple of them on Amazon suffice? I want to buy them tomorrow if
possible :)
--- In Rob Danielson <> wrote:
>
> At 8:00 PM +0000 6/29/09, brucethehoon wrote:
> >Thank you so much for your reply. The number of private email
> >replies I got rather overwhelmed me and as such I didn't get back to
> >the group in my usual speedy manner.
> >
> >To update, I have purchased the PCM-D50, realizing that I really
> >don't care how much this costs, but ruggedness is a factor.
> >
> >That said, as requested below, my first and most important use will
> >be to record one hour or more of waves / surf at a california beach
> >with 30mph winds gusting to 50mph.
> >
> >I will have the unit on a sand compatible tripod (legs buried) and
> >would like to record the EXPERIENCE of being there. While not
> >necessarily suggesting a binaural setup, I would like to play it
> >back later and be fairly able to close my eyes and be there again.
> >
> >If I was able to pack the whole setup (excluding tripod) into an
> >average sized backback, that would be "portable" for me.
> >
> >Spending ANOTHER $300-500 on microphones seems reasonable to me. I
> >can appreciate that it might seem absurd to drop so much in advance,
> >but I would rather take the risk of spending too much money than
> >take the risk of getting a lower quality recording during a once in
> >a lifetime trip.
> >
> >I am using Shure E5C's as my listening method, so I suppose anything
> >they can't play, I don't care about, when it comes to quality :)
> >
>
> Hi Bruce--
> In the $300-$500/pair price range, the rigs that John Hartog and
> variations others have made for Rode NT1-A's have produced striking
> recordings and these ultra low-noise mics provide the ability to
> record very quiet locations too.
> http://www.rockscallop.org/how/barrier10.html Any condenser mic will
> require phantom powering which the PCM-D50 doesn't have. The cheapest
> way to provide phantom powering (with no compromise in quality) is
> with a portable phantom power supply like an Art Phantom II or Rolls
> PB224.
>
> For dealing with steady winds that strong, Rich Peet has some designs
> made with "Shop Vac" filters that work very well. [Contact him
> directly at If you go with a traditional
> zeppelin approach, I'd favor a larger than usual "basket" size with
> 3-4" of dead air space around the capsules, an inner liner made of
> taut panty hose stocking and an outer layer of long pile fake fur (2"
> or longer). Here are some NT1-A ideas:
> http://www.uwm.edu/~type/audio-reports/Rode_NT1-A_Mics/NT1-A_index.htm
>
> Another thought. Surf and wind are quite loud so you can get by with
> small electret mics and put some energy into making wind protection
> for them. The tiny Panasonic WM-61A's mics are very accurate in terms
> of tonal response and can be purchased in a variety of packages well
> under $100 a pair:
> http://www.uwm.edu/~type/audio-reports/PanasonicWM-61A_OtherBinauralRigs/docs/CompareCommercialLavs_1_2009.doc
>
> The popular Shure WL-183's are larger and quieter. You'll find lots
> of discussion about the WL-183's in the list archive. These electret
> mics will produce considerable "hiss" if used in quiet locations
> where the record level is turned up high but they are fine in loud
> locations. Rob D.
>
>
>
> --
>
|