naturerecordists
[Top] [All Lists]

Re: Any suggestions for thin, ultra-flexible mic cable?

Subject: Re: Any suggestions for thin, ultra-flexible mic cable?
From: "anthonyllarson" anthonyllarson
Date: Thu Jun 11, 2009 4:10 pm ((PDT))
Check this out:
http://taperssection.com/index.php/topic,122530.0.html
Some options, buying it in bulk, etc.

A

--- In  "walunit" <> wrote:
>
> Hi all,
> I'm making a microphone cable shock mount / vibration isolation setup for=
 my MKH30/40 setup. I have the Sennheiser handle/blimp.
> At the last recording workshop here in Washington Martyn showed me the Ry=
cote connbox system: http://www.rycote.com/products/families/connboxes/
> Looks like a wonderful solution, but I cannot afford this right now.
> Do you have any clever ideas on finding a few feet of the nice ultra-flex=
ible, low-mass, shielded twisted pair that is used to connect from the "box=
" to the microphone connector?
> I attempted a search on the archives and found a suggestion for pulling o=
ne piece out of a multi-channel snake. I haven't tried that yet and am not =
sure if I have a balanced snake to cannibalize. If nothing obvious pops up =
I'll try that with a HOSA, ProCo snake, or something similar.
> I ordered several pieces of the "thinnest" mic cable available(in bulk) f=
rom Markertek, including Canare L-2E5 but all of them are more rigid than I=
'd like for this application.
> A few feet of such cable will probably last me a lifetime.
> I'm attempting to join the Mic builders DIY group to ask there as well.
> Thanks so much for any suggestions.
> -Mike
>








<Prev in Thread] Current Thread [Next in Thread>
Admin

The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU