Thank you David,
I already do what you said yesterday before i posted this topic.
#ts7500tcl --setdiodir=0xfffffffffffff
The result on TS7500 is reboot.
--- In David Preza H <> wrote:
>
> You first need to configure if the pins are going to be inputs or outputs.
> You can do this with ts7500ctl --setdiodir, and it will be something like
> ts7500tcl --setdiodir=0xfffffffffffff (This will enable all pins as outputs).
> After that, you have to use --setdio to actually give a value to the piÅ?s.
> ts7500ctl --setdio=0xffffffffffffff (This will set all the DIO to 1).
>
> I don't remember at this moment if anything more else is needed in the
> command, but as far as I remember, it's correct.
> Just remeber you don't have the full 40 DIO, because some of the pins are for
> 3.3V, 5V, GND SPI, and usart functions, so check the pinout schemmatic on
> embeddedarm webpage.
>
> Regards,
>
> Enrique
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|