Re: [ts-7000] Re: RS-232 ts7800 /dev/ttts*

[Joe Mari Maja <>]

Hi Romain,

I just checked my inittab today and I cannot find the ttts4 on Com3 - what I have is tty4 and its already commented.

Try doing the stty -F again and check if you have an error?

joe

On Wed, Apr 21, 2010 at 3:13 AM, rodriguezromain62 <> wrote:

 

I see the file you said me, but what write in??
Its not ttyS4 but ttts4 on COM3.

--- In ts-7000%40yahoogroups.com, Joe Mari Maja <> wrote:
>
> Hi romain,
>
> I am using the same board as you are. when you do the following:
>
> # stty -F /dev/ttyS4 baudrate
>
> you get no error on it?
>
> I haven't gone through up to that port nos. yet - but before I have problems
> with com2 - all I did was to comment the ttyS1 in inittab file under /etc.
> and everything works fine.
>
> joe
>
>
> On Tue, Apr 20, 2010 at 7:30 AM, rodriguezromain62 <

> > wrote:
>
> >
> >
> > Hello everybody, I have a problem with serial port now =)
> >
> > I use stty -F /dev/ttts4 for configure my serial port with 9600 bauds and
> > other parameters...
> > After, with a network analyzer, I send some char with the same config.
> >
> > On my TS7800, i use 'cat /dev/ttts4' for read. But I read anything :S
> > I dont understand why, Do you have an idea?
> >
> > Thanks
> >
> >
> >
>

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___