I found a few other instances of this by searching...anyone know what causes
this?
I took this 1GB flash drive and formatted it as FAT on a Windows PC before
plugging it in, so it definitely works :-P
dmesg reports this:
VFS: Disk change detected on device 08:00
SCSI device sda: 1957888 512-byte hdwr sectors (1002 MB)
sda: Write Protect is off
/dev/scsi/host0/bus0/target0/lun0: p1
usb.c: USB disconnect on device not_pci-1 address 21
VFS: Disk change detected on device 08:00
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
Device not ready. Make sure there is a disc in the drive.
I/O error: dev 08:00, sector 0
Device not ready. Make sure there is a disc in the drive.
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
Device not ready. Make sure there is a disc in the drive.
sda: Unit Not Ready, sense:
Info fld=0xa00 (nonstd), Current 00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Info fld=0xa00 (nonstd), Current sd00:00: sns = 70 2
Raw sense data:0x70 0x00 0x02 0x00 0x00 0x0a 0x00 0x00
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: test WP failed, assume Write Enabled
/dev/scsi/host0/bus0/target0/lun0: I/O error: dev 08:00, sector 0
I/O error: dev 08:00, sector 0
unable to read partition table
I/O error: dev 08:00, sector 0
Device not ready. Make sure there is a disc in the drive.
hub.c: new USB device not_pci-1, assigned address 22
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 22
usb.c: USB disconnect on device not_pci-1 address 22
hub.c: new USB device not_pci-1, assigned address 23
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 23
usb.c: USB disconnect on device not_pci-1 address 23
hub.c: new USB device not_pci-1, assigned address 24
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 24
usb.c: USB disconnect on device not_pci-1 address 24
hub.c: new USB device not_pci-1, assigned address 25
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 25
usb.c: USB disconnect on device not_pci-1 address 25
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|