ts7300 wrote:
> below routing table
> Destination Gateway Genmask Flags Metric Ref Use Iface
> 10.64.0.0 * 255.255.0.0 U 0 0 0 wlan0
> 10.64.0.0 * 255.255.0.0 U 0 0 0 eth0
> default 10.64.1.1 0.0.0.0 UG 0 0 0 wlan0
> default 10.64.1.1 0.0.0.0 UG 0 0 0 eth0
> can you elborate bit more about how to use bridge mode.according to routing
> table subnet mask is same but again doubt is on gateway when wlan0 set
> 10.64.1.1 Gateway then its might replace eth0 interface with wlan0 interface
> thats why fail to ping when wlan0 default gateway is used.
You shouldn't have IP's on the interfaces. I'm not sure if the TS
kernel has the required code compiled in or as a module, or at all but
you need Ethernet Bridging support in the kernel. You also need the
program brctl to create a bridge. You can then assign the bridge
interface a IP. The bridge interface can be called anything.
--
Jason Stahls
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|