Thanx for prompt reply.Now I am trying to use bridge mode.First of all
started with insmod/libmodules/2.4.26-ts11/kernel/net/bridge.o
/lib/modules/2.4.26-ts11/kernel/net/bridge.o:
/lib/modules/2.4.26-ts11/kernel/net/bridge.o: unresolved symbol
br_ioctl_hook
/lib/modules/2.4.26-ts11/kernel/net/bridge.o:
/lib/modules/2.4.26-ts11/kernel/net/bridge.o: unresolved symbol
br_handle_frame_hook
Can any have any Idea on this.Or I have to install some additional package for
this.
waiting for eary response.
----------------------------------------------
--- In Jason Stahls <> wrote:
>
> ts7300 wrote:
> > below routing table
> > Destination Gateway Genmask Flags Metric Ref Use Iface
> > 10.64.0.0 * 255.255.0.0 U 0 0 0 wlan0
> > 10.64.0.0 * 255.255.0.0 U 0 0 0 eth0
> > default 10.64.1.1 0.0.0.0 UG 0 0 0 wlan0
> > default 10.64.1.1 0.0.0.0 UG 0 0 0 eth0
> > can you elborate bit more about how to use bridge mode.according to routing
> > table subnet mask is same but again doubt is on gateway when wlan0 set
> > 10.64.1.1 Gateway then its might replace eth0 interface with wlan0
> > interface thats why fail to ping when wlan0 default gateway is used.
>
> You shouldn't have IP's on the interfaces. I'm not sure if the TS
> kernel has the required code compiled in or as a module, or at all but
> you need Ethernet Bridging support in the kernel. You also need the
> program brctl to create a bridge. You can then assign the bridge
> interface a IP. The bridge interface can be called anything.
>
> --
> Jason Stahls
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|