ts-7000
[Top] [All Lists]

Re: [ts-7000] Boot new kernel on TS-7800

To:
Subject: Re: [ts-7000] Boot new kernel on TS-7800
From: HaJee H <>
Date: Mon, 9 Jun 2008 14:14:50 -0700 (PDT)
Oke, that explains why after a reboot the new kernel isn't loaded.

The method i used is based on compiling a new debian kernel and creates an installable package.
The is compiled using the kernel sources we provide at
ftp://ftp.embeddedA RM.com/ts- arm-sbc/ts- 7800-linux/ sources/linux- 2.6.21-ts- src-latest. tar.gz

On your website I read your method of compiling a new kernel.
Just to be sure. For compiling a new kernel (for a ts7800):

make menuconfig
make ts7800_config
make oldconfig
make dep

and than dd the new kernel to partition 2.

and for the new modules:

make modules
make modules_install

TIA

HaJee

----- Original Message ----
From: Michael Schmidt <>
To:
Sent: Monday, June 9, 2008 10:00:09 PM
Subject: Re: [ts-7000] Boot new kernel on TS-7800

Michael Schmidt wrote:
> HaJee H wrote:
>> Hi,
>>
> > > The installation of the new kernel is not a problem,
>> I installed the kernel with dpkg -i linux-image- custom.deb.
>> The kernel is compiled with:
>> make-kpkg clean
>> make-kpkg kernel-images (also with --initrd)
>
> The TS-BOOTROM bootloader doesn't use the Debian partition to load the
> kernel.
>
> To install the kernel you'll need to dd the kernel image to the kernel
> partition (partition 2 on the SD card or partition 1 on the on-board
> flash).
>

Oh and I also should add I'm not sure what kernel source that is going
to install if you use make-kpkg, as I've never used that before. Is it
using the kernel sources we provide at
ftp://ftp.embeddedA RM.com/ts- arm-sbc/ts- 7800-linux/ sources/linux- 2.6.21-ts- src-latest. tar.gz

?

______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM. com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddeda rm.com/~michael


__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___
<Prev in Thread] Current Thread [Next in Thread>
Admin

Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU