All I find on the datasheet was a answer starting with 0xcc, not 0x82
And I didn't find what code I suppose to send to have some other info
on the status.
As for the transparent mode, it should be by default, but seeing where
you work you know that !!
Anyway if you find something I take 100%.
thanks for your help.
arno
--- In "Michael Schmidt" <> wrote:
>
>
> On Thu, December 27, 2007 3:08 pm, trucmuch_59 wrote:
> > No error messages !!
>
> Oh! well then it's working... ;-)
>
> > When I try to print some stuff (how moutch data I wrote=6)
> > and what I read from the aero:
> > aerocomm radio:0x82 - 0 - 0 - 0x80
> >
> > Instead of having 0xcc 0x43 0x4f 0x4d
>
> Well what the sample program is doing is sending bytes to program the
> EEprom on the Aero radio to enter transparent serial mode by default. I
> would have to consult the data sheet, but the reply you are getting
sounds
> reasonable.
>
> > But I have to say that the board is for a 900Mhz module not the 2.4,
> > but if I look the pinout it's the same.
>
> Yes, both radios share the same serial port interface.
>
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
> http://oz.embeddedarm.com/~michael
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|