On Thu, December 27, 2007 3:08 pm, trucmuch_59 wrote:
> No error messages !!
Oh! well then it's working... ;-)
> When I try to print some stuff (how moutch data I wrote=6)
> and what I read from the aero:
> aerocomm radio:0x82 - 0 - 0 - 0x80
>
> Instead of having 0xcc 0x43 0x4f 0x4d
Well what the sample program is doing is sending bytes to program the
EEprom on the Aero radio to enter transparent serial mode by default. I
would have to consult the data sheet, but the reply you are getting sounds
reasonable.
> But I have to say that the board is for a 900Mhz module not the 2.4,
> but if I look the pinout it's the same.
Yes, both radios share the same serial port interface.
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|