On Thu, December 27, 2007 12:08 pm, trucmuch_59 wrote:
> Hello,
> I try to make my aero board working, but it's look like it's not.
> here is the messages I got on the dmesg:
> TS-UART/RF2 found at port 0x0100
> ttyTS1 at I/O 0x89e00102 (irq = 40) is a TSUART
>
>
> But when I ty the aeroee.c from TechSystem it doesn't see my board.
> Does I have to load a program to be able to use it or not ?
> The aero module (a 2.4Ghz module) Is working i was able to put it on a
> PC in it's default config (115200bps), but not on my pc104 board.
>
> any clue what to do or look for ?
The dmesg message you get suggest that the TS-RF2 board is being
recognized by the driver. The aeroee.c sample program defaults to using
/dev/ttyTS1, which is the device that is being used. So it looks like
everything should be working, assuming you have the Aero radio module on
your TS-RF2 board.
What error messages are you getting when you run the aeroee program?
> thanks in advance,
>
> arno
______ Best Regards,
|__ __/ Michael Schmidt
|| Software Engineer
||echnologic Systems (EmbeddedARM.com)
|| (480) 16610 East Laser Drive #10
|/ 837-5200 Fountain Hills, AZ 85268
http://oz.embeddedarm.com/~michael
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|