No error messages !!
When I try to print some stuff (how moutch data I wrote=6)
and what I read from the aero:
aerocomm radio:0x82 - 0 - 0 - 0x80
Instead of having 0xcc 0x43 0x4f 0x4d
But I have to say that the board is for a 900Mhz module not the 2.4,
but if I look the pinout it's the same.
--- In "Michael Schmidt" <> wrote:
>
>
> On Thu, December 27, 2007 12:08 pm, trucmuch_59 wrote:
> > Hello,
> > I try to make my aero board working, but it's look like it's not.
> > here is the messages I got on the dmesg:
> > TS-UART/RF2 found at port 0x0100
> > ttyTS1 at I/O 0x89e00102 (irq = 40) is a TSUART
> >
> >
> > But when I ty the aeroee.c from TechSystem it doesn't see my board.
> > Does I have to load a program to be able to use it or not ?
> > The aero module (a 2.4Ghz module) Is working i was able to put it on a
> > PC in it's default config (115200bps), but not on my pc104 board.
> >
> > any clue what to do or look for ?
>
> The dmesg message you get suggest that the TS-RF2 board is being
> recognized by the driver. The aeroee.c sample program defaults to
using
> /dev/ttyTS1, which is the device that is being used. So it looks like
> everything should be working, assuming you have the Aero radio module on
> your TS-RF2 board.
>
> What error messages are you getting when you run the aeroee program?
>
> > thanks in advance,
> >
> > arno
>
>
> ______ Best Regards,
> |__ __/ Michael Schmidt
> || Software Engineer
> ||echnologic Systems (EmbeddedARM.com)
> || (480) 16610 East Laser Drive #10
> |/ 837-5200 Fountain Hills, AZ 85268
> http://oz.embeddedarm.com/~michael
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|