Since posting this, all of 10 minutes ago, I was able to get it working
on COM1 but still not on COM2 (where I would prefer it connected). I
realize it is a 10 pin header but I'm looking at the hardware manual
and it seems to indicate that pinouts should corrispond to the DB9
connector. Is there somethign that needs to be done to put this in RS-
232 mode or am I wrong about the pinout? Or anything else I am missing?
--- In "BillBergeron" <> wrote:
>
> Does anyone know the Rx and Tx voltage specs for the TS-7260? I have
> a satellite modem that uses the serial port to connect with RS-232.
> According to the specs on the modem the signal is sent using 12V. It
> works fine on a PC (and I've tried several) and I am 99% sure I have
> ruled out any port setting issues. I just want to see if there is a
> hardware incompatibility before I keep banging my head against the
> wall trying to make it work.
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|