If you know socket programming and serial port programing, this is not too difficult. On the board, you can open the serial port(s) you need, and, you accept socket connections for standard TCP/IP. You will have a file descriptor for the serial port, and for the socket. You could make a straight pass through, and any data received on one, would then be passed on to the other, or you might implement some type of protocol, and use one socket to talk to multiple serial ports. You have to give us a little more info for us to help you here. Don.
On 5/9/07, cingospet <> wrote:
--- In ts-7000%40yahoogroups.com, Bas Schulte <> wrote:
>
> Hi,
>
> On 8-mei-2007, at 17:16, oj199933 wrote:
>
> > I've ordered a couple of TS-7400 boards which I'll receive soon.
> > These boards will be used to control a couple of small robots.
> > The robots have to communicate via the wifi usb dongle (an option for
> > this board).
> >
> > Since I can't find much information about the wifi driver that already
> > exists for this board, it's hard for me to understand how I have to
> > write an application in C that can perform a simple task like sending
> > a string to the other board (and off course receiving that string on
> > the other end).
>
> I think you're trying to make this more difficult than it is. WiFi
> allows you to setup a regular tcp/ip network (although it is
> wireless) so you just write tcp/ip servers and clients as
> appropriate, just as if they're in a regular ethernet tcp/ip network.
>
Any suggestion on how to connect the programmer interface with the RS-232 drivers and
the WiFi board at the same time?
-- Dr. Don W. Carr J. G. Montenegro 2258 Guadalajara, Mexico +52-333-630-0704 +52-333-836-4500 ext 2930
__._,_.___
![]()
SPONSORED LINKS
__,_._,___
|