Hi ,
The Linux kernel bundled with this board could not provide precise
timing for servo motor. If you just want to drive servo motor, I would
suggest you got a servo motor controller from other sources:
http://www.parallax.com/detail.asp?product_id=28023
http://www.wse.com.hk/Accessories%20Parts.htm
noone_1983 wrote:
>
> Hey everyone,
> I was wondering if anyone had any experience controlling hardware
> (in this case a servo) with the board that needed to have precision
> timing. The signal I generate on the output pin has to be a very
> precisely timed series of pulses, and the nanosleep function just
> doesn't seem to cut it running on the board. Any ideas?
>
> Thanks,
> Sajendra N.
>
>
>
>
> *Yahoo! Groups Sponsor*
> ADVERTISEMENT
> click here
> <http://us.ard.yahoo.com/SIG=129nf2ekq/M=298184.6191685.7192823.3001176/D=groups/S=1705005378:HM/EXP=1111371518/A=2593423/R=0/SIG=11el9gslf/*http://www.netflix.com/Default?mqso=60190075>
>
>
>
>
> ------------------------------------------------------------------------
> *Yahoo! Groups Links*
>
> * To visit your group on the web, go to:
> http://groups.yahoo.com/group/ts-7000/
>
> * To unsubscribe from this group, send an email to:
>
> <=Unsubscribe>
>
> * Your use of Yahoo! Groups is subject to the Yahoo! Terms of
> Service <http://docs.yahoo.com/info/terms/>.
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|