| Subject: | Re: Tips DIY for Primo Em172 |
|---|---|
| From: | "Scott Fraser" scottbfraser |
| Date: | Mon Sep 17, 2012 7:44 am ((PDT)) |
<< To sum up, minimal contact, set up for efficiency, low voltage, low melt= ing point for solder, plenty of flux... >> Actually, not low voltage. Low wattage, i.e. 25 watts. The gun-type solderi= ng units are typically 75 watts & not intended for electronics. But the low= wattage irons still run on mains voltage, presumably 220 volts in Vietnam. Scott Fraser |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: MX391's and M-10 at the Hummingbird Feeder, Robin |
|---|---|
| Next by Date: | Re: Tips DIY for Primo Em172, Mark |
| Previous by Thread: | Re: Tips DIY for Primo Em172, Mark |
| Next by Thread: | Re: Tips DIY for Primo Em172, Mark |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
The University of NSW School of Computer and Engineering takes no responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the naturerecordists mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU