At 11:12 PM -0500 12/17/04, Walter Knapp wrote:
>
>I would also get a layer of wind stopping fabric into the mesh. In
>addition to the furry outside. You have only a single layer of protection.
that would be good to try. Do you have a source for this?
>
>You might also look at craft shop "plastic canvas" for the mesh.
I should compare these sonically. The gutter mesh is really cheap--
when we make up 20 mics it adds up.
>
>I favor o-rings over rubber bands. You can get all kinds of different
>types in bulk here:
>http://www.allorings.com/material_selection.htm
>
>I prefer the Silicone ones in my SASS as they don't tend to stick to the
>mics over time. That's the same as Rycote uses I'm pretty sure. I have
>some of the Rycote ones and they look the same. You have to check the
>sizing chart to understand the ordering page.
Great idea. I asked them if they'd consider a $10 sample kit for
microphone applications.
Rob D.
--
Rob Danielson
Film Department
University of Wisconsin-Milwaukee
________________________________________________________________________
________________________________________________________________________
|