|
Finally, the ts7260 board boot directly from the sd card, after I delete the tsfastboot file on the Debian file system. Don and Mark, thanks for your support. Regards, Ricardo De: Don Tucker <> Para: Enviado: martes, 31 de enero de 2012 19:51 Asunto: Re: [ts-7000] Boot debian on sd card Also, make sure that there is no /tsfastboot file on the Debian file system. That file will force you into the shell prompt. Don On 1/31/2012 4:33 PM, Ricardo Gabriel wrote: > > Don and Mark, thanks for your support. > > I downloaded the sd card image for the ts7260 board from ftp.embeddedarm.com <ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7260-linux/binaries/ts-images/sdimage-new.dd.bz2>. > This image works very well > > Apparently, the previous image that came with the card with the ts7260 board I bought, had a problem. > I do not know why. > > One more question, > How do I get my debian system boot directly? without having to type exit after startup. > > Regards, > > > Ricardo > > > ------------------------------------------------------------------------ > *De:* Ricardo Gabri el <m("yahoo.com.ar","ricardogabriel5");" href="">> > *Para:* Mark Featherston <m("embeddedarm.com","mark");" href="">>; "m("yahoogroups.com","ts-7000");" href="">" <m("yahoogroups.com","ts-7000");" href="">> > *Enviado:* martes, 31 de enero de 2012 13:52 > *Asunto:* Re: [ts-7000] Boot debian on sd card > > > Thanks Mark! > > I will download that image. > > Then, I will write comment if it works. > > I hope to get lucky! > > > Ricardo > > > ------------------------------------------------------------------------ > *De:* Mark Featherston <m("embeddedarm.com","mark");" href="">> > *Para:* m("yahoogroups.com","ts-7000");" href=""> > *CC:* Ricardo Gabriel <m("yahoo.com.ar","ricardogabriel5");" href="">> > *Enviado:* martes, 31 de enero de 2012 13:39 > *Asunto:* Re: [ts-7000] Boot debian on sd card > > Ricardo, > > The first two lines are printed from the bootrom, but normally it will print three dots after. The first dot says that it loaded and executed the MBR from the SD card followed by a dot for loading the kernel and one for the initrd. This is normally not needed if you're first booting to the onboard flash and then to SD. However with the bootrom change you will need this new MBR in place which will not be there with the stock SD image. > > Try booting this image: > ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7260-linux/binaries/ts-images/sdimage-new.dd.bz2 > Best Regards, > ________________________________________________________________ > Mark Featherston, Technologic Systems | voice: (480) 837-5200 > 16525 East Laser Drive | fax: (480) 837-5300 > Fountain Hills, AZ 85268 | web:www.embeddedARM.com <http://www.embeddedARM.com> > On 01/31/2012 09:33 AM, Ricardo Gabriel wrote: >> >> The SD card comes with the ts7260 board. >> >> >> Ricardo >> >> ------------------------------------------------------------------------ >> *De:* Don Tucker <m("arlut.utexas.edu","dtucker");" href="">> <mailto:m("arlut.utexas.edu","dtucker");" href="">> >> *Para:* m("yahoogroups.com","ts-7000");" href=""> <mailto:m("yahoogroups.com","ts-7000");" href="">> >> *Enviado:* martes, 31 de enero de 2012 13:23 >> *Asunto:* Re: [ts-7000] Boot debian on sd card >> >> Uh oh. That's not a good sign. Where did you get your SD card image? >> >> Don >> >> On 1/31/2012 10:13 AM, Ricardo Gabriel wrote: >> > Hi Don! >> > >> > I followed your instructions. >> > >> > After completing step 15, restart the ts7260board, but the system does not boot. >> > >> > Only the following message appears repeatedly: >> > >> > >> > >> TS-SDBOOT - built Aug 10 2009 >> > >> Copyright (c) 2007, Technologic Systems >> > >> > >> > >> TS-SDBOOT - built Aug 10 2009 >> > >> Copyright (c) 2007, Technologic Systems >> > >> > >> > >> TS-SDBOOT - built Aug 10 2009 >> > >> Copyright (c) 2007, Technologic Systems >> > >> > Is there any way to recover the boot? >> > >> > >> > Ricardo >> > >> > >> > >> > ------------------------------------------------------------------------ >> > *De:* Don Tucker <m("arlut.utexas.edu","dtucker");" href=""> <mailto:m("arlut.utexas.edu","dtucker");" href="">>> >> > *Para:* m("yahoogroups.com","ts-7000");" href=""> <mailto:m("yahoogroups.com","ts-7000");" href="">> >> > *Enviado:* lunes, 30 de enero de 2012 14:14 >> > *Asunto:* Re: [ts-7000] Boot debian on sd card >> > >> > NOTE: The following procedure is IRREVERSIBLE. >> > >> > 1.Download the tsbootrom-update from ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7200-linux/binaries/ts-u! tils/tsbootrom-update <ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7200-linux/binaries/ts-utils/tsbootrom-update> <ftp://ftp.embeddedarm.com/ts-arm-sbc/ts-7200-linux/binaries/ts-utils/tsbootrom-update%3E> and put it onto a USB flash drive. >> > 2.Boot into a stock TS-7260 using the development interface. Type 'root' to log in. >> > 3.run /usr/bin/loadUSBModules.sh >> > 4.Plug in the USB flash drive and you will see a message indicating where it is mounted (e.g. /dev/scsi/host0/bus0/target0/lun0/part1 ). >> > 5.Type mount /dev/scsi/host0/bus0/target0/lun0/part1 /mnt . This will mount the device at /mnt . >> > 6.Copy tsbootrom-update from the /mnt directory over onto the /root directory. >> > 7.Return to /root and type umount /dev/scsi/host0/bus0/target0/lun0/part1 to unmount the device. THIS MUST BE DONE or you risk corrupting the file system (if there is one) on the USB device upon power down or removal. >> > 8.Type mac=`ifconfig eth0 | grep HWaddr | cut -d' ' -f11` >> > 9.Then type tsbootrom-update -s -m $mac NOTE: If this is not done you will lose your MAC address forever. >> > 10.Place the SD card into the TS-7260 SD card slot and reboot the TS-7260. >> > 11.You should boot into the fastboot shell after a few seconds. From within the shell, type the following: >> > 12.ln -sf /linuxrc-sdroot /linuxrc >> > 13.sync >> > 14.save >> > 15.reboot This should boot the TS7260 to a login prompt on the Debian file system of the SD card. You may have to try creating this link a few times before it actually saves. >> > 16.See this link (http://www.embeddedarm.com/software/arm-linux-fastboot-ts7300.php) for more information. >> > >> > Don >> > On 1/30/2012 11:02 AM, ricardogabriel5 wrote: >> > > >> > > Hi! >> > > >> > > I have a TS7260 board and sd card with debian linux. >> > > >> > > The sd card has 3 partitions: >> > > >> > > The second and thrid partitions have files. But the first partition is empty with an unknown format >> > > >> > > What steps should I follow to make the board boot from sd card? >> > > >> > > Regards, >> > > >> > > Ricardo >> > > >> > > >> > >> > >> > >> > >> >> >> > > > > > __._,_.___
Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required) Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe __,_._,___ |