Petr
Here's the output I get from a 2.6.34.7 build.
Ian T.
[ 0.000000] Linux version 2.6.34.7 (gcc version
4.5.2 (Ubuntu/Linaro 4.5.2-8ubuntu3) ) #14 PREEMPT Mon May 23 08:48:06
CDT 2011
[ 0.000000] CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=40007177
[ 0.000000] CPU: VIVT data cache, VIVT instruction cache
[ 0.000000] Machine: Technologic Systems TS-72xx SBC
[ 0.000000] Memory policy: ECC disabled, Data cache writeback
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on.
Total pages: 9040
[ 0.000000] Kernel command line: console=ttyAM0,115200 root=/dev/ram0
rw init=/linuxrc
[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
[ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Memory: 8MB 8MB 8MB 8MB 8MB 8MB 8MB 8MB = 64MB total
[ 0.000000] Memory: 56820k/56820k available, 8716k reserved, 0K highmem
[ 0.000000] Virtual kernel memory layout:
[ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB)
[ 0.000000] fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
[ 0.000000] DMA : 0xffc00000 - 0xffe00000 ( 2 MB)
[ 0.000000] vmalloc : 0xce000000 - 0xfe800000 ( 776 MB)
[ 0.000000] lowmem : 0xc0000000 - 0xcd800000 ( 216 MB)
[ 0.000000] modules : 0xbf000000 - 0xc0000000 ( 16 MB)
[ 0.000000] .init : 0xc0008000 - 0xc0023000 ( 108 kB)
[ 0.000000] .text : 0xc0023000 - 0xc038c000 (3492 kB)
[ 0.000000] .data : 0xc03a4000 - 0xc03c4c20 ( 132 kB)
[ 0.000000] Hierarchical RCU implementation.
[ 0.000000] NR_IRQS:120
[ 0.000000] VIC @fefb0000: id 0x00041190, vendor 0x41
[ 0.000000] VIC @fefc0000: id 0x00041190, vendor 0x41
[ 0.000000] Console: colour dummy device 80x30
[ 0.000000] Calibrating delay loop... 99.73 BogoMIPS (lpj=498688)
[ 4.300000] Security Framework initialized
[ 4.300000] Mount-cache hash table entries: 512
[ 4.300000] CPU: Testing write buffer coherency: ok
[ 4.300000] devtmpfs: initialized
[ 4.300000] NET: Registered protocol family 16
[ 4.310000] ep93xx clock: PLL1 running at 400 MHz, PLL2 at 192 MHz
[ 4.310000] ep93xx clock: FCLK 200 MHz, HCLK 100 MHz, PCLK 50 MHz
[ 4.310000] ep93xx dma_m2p: M2P DMA subsystem initialized
[ 4.310000] ep93xx dma_m2m: M2M DMA subsystem initialized
[ 4.320000] bio: create slab <bio-0> at 0
[ 4.330000] NET: Registered protocol family 2
[ 4.330000] IP route cache hash table entries: 1024 (order: 0, 4096
bytes)
[ 4.330000] TCP established hash table entries: 2048 (order: 2, 16384
bytes)
[ 4.330000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
[ 4.330000] TCP: Hash tables configured (established 2048 bind 2048)
[ 4.330000] TCP reno registered
[ 4.330000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 4.330000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 4.330000] NET: Registered protocol family 1
[ 4.340000] RPC: Registered udp transport module.
[ 4.340000] RPC: Registered tcp transport module.
[ 4.340000] RPC: Registered tcp NFSv4.1 backchannel transport module.
[ 4.340000] Trying to unpack rootfs image as initramfs...
[ 4.340000] rootfs image is not initramfs (junk in compressed
archive); looks like an initrd
[ 4.440000] Freeing initrd memory: 4096K
[ 4.440000] JFS: nTxBlock = 475, nTxLock = 3807
[ 4.450000] msgmni has been set to 118
[ 4.460000] alg: No test for stdrng (krng)
[ 4.460000] Block layer SCSI generic (bsg) driver version 0.4 loaded
(major 253)
[ 4.460000] io scheduler noop registered
[ 4.460000] io scheduler cfq registered (default)
[ 4.500000] Serial: AMBA driver
[ 4.500000] apb:uart1: ttyAM0 at MMIO 0x808c0000 (irq = 52) is a AMBA
[ 4.840000] console [ttyAM0] enabled
[ 4.850000] apb:uart2: ttyAM1 at MMIO 0x808d0000 (irq = 54) is a AMBA
[ 4.850000] apb:uart3: ttyAM2 at MMIO 0x808e0000 (irq = 55) is a AMBA
[ 4.890000] brd: module loaded
[ 4.900000] loop: module loaded
[ 4.910000] No NAND device found.
[ 4.920000] ep93xx_mii_bus: probed
[ 4.920000] ep93xx_eth:ep93xx_mii_probe: PHY supports MII frame
preamble suppression
[ 4.930000] ep93xx_eth:ep93xx_mii_probe: attached PHY driver [Generic
PHY] (mii_bus:phy_addr=0:01, irq=-1)
[ 4.940000] net eth0: ep93xx on-chip ethernet, IRQ 39, 00:d0:69:41:51:cb
[ 4.950000] wdt: ts72xx stopped
[ 4.950000] ts72xx-wdt ts72xx-wdt: TS-72xx Watchdog driver
[ 4.970000] TCP cubic registered
[ 4.970000] NET: Registered protocol family 17
[ 4.980000] drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
[ 4.990000] RAMDISK: ext2 filesystem found at block 0
[ 4.990000] RAMDISK: Loading 1536KiB [1 disk] into ram disk... done.
[ 5.250000] EXT2-fs (ram0): warning: mounting unchecked fs, running
e2fsck is recommended
[ 5.260000] VFS: Mounted root (ext2 filesystem) on device 1:0.
[ 5.270000] devtmpfs: mounted
[ 5.270000] Freeing init memory: 108K
[ 5.300000] Kernel panic - not syncing: Attempted to kill init!
[ 5.300000] [<c002895c>] (unwind_backtrace+0x0/0xf0) from
[<c02c6294>] (panic+0x5c/0xd8)
[ 5.310000] [<c02c6294>] (panic+0x5c/0xd8) from [<c00398e4>]
(do_exit+0x614/0x6bc)
[ 5.320000] [<c00398e4>] (do_exit+0x614/0x6bc) from [<c0039c64>]
(do_group_exit+0x3c/0xe4)
[ 5.330000] [<c0039c64>] (do_group_exit+0x3c/0xe4) from [<c0044570>]
(get_signal_to_deliver+0x1dc/0x448)
[ 5.340000] [<c0044570>] (get_signal_to_deliver+0x1dc/0x448) from
[<c0026120>] (do_signal+0x4c/0x5b0)
[ 5.350000] [<c0026120>] (do_signal+0x4c/0x5b0) from [<c0026c18>]
(do_notify_resume+0x60/0x6c)
[ 5.360000] [<c0026c18>] (do_notify_resume+0x60/0x6c) from
[<c0023f8c>] (work_pending+0x1c/0x20)
This e-mail, including any attachments and response string, may contain
proprietary information which is confidential and may be legally privileged. It
is for the intended recipient only. If you are not the intended recipient or
transmission error has misdirected this e-mail, please notify the author by
return e-mail and delete this message and any attachment immediately. If you
are not the intended recipient you must not use, disclose, distribute, forward,
copy, print or rely on this e-mail in any way except as permitted by the author.
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|