| To: | |
|---|---|
| Subject: | Re: [ts-7000] DIO 1 Header PIN polarity |
| From: | Don Tucker <> |
| Date: | Tue, 29 Mar 2011 11:10:15 -0500 |
I think I was seeing something similar on my board. The next day I was no longer seeing it, however, and I just assumed that I was not using the ribbon connector correctly. Can you reboot and see if you are still seeing the problem? Don On 3/29/2011 10:19 AM, wgwend wrote: The ts-7260-manual says that pin 1 on DIO 1 header is GND and pin 16 is + 3,3 V. But I have it inverted. Is this possible?
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [ts-7000] DIO 1 Header PIN polarity, wgwend |
|---|---|
| Next by Date: | Re: [ts-7000] DIO 1 Header PIN polarity, Joel Morgan |
| Previous by Thread: | [ts-7000] DIO 1 Header PIN polarity, wgwend |
| Next by Thread: | Re: [ts-7000] DIO 1 Header PIN polarity, Joel Morgan |
| Indexes: | [Date] [Thread] [Top] [All Lists] |
Disclaimer: Neither Andrew Taylor nor the University of NSW School of Computer and Engineering take any responsibility for the contents of this archive. It is purely a compilation of material sent by many people to the birding-aus mailing list. It has not been checked for accuracy nor its content verified in any way. If you wish to get material removed from the archive or have other queries about the archive e-mail Andrew Taylor at this address: andrewt@cse.unsw.EDU.AU
