FYI, Technologic Systems confirmed this morning that their 2.6 kernel driver
(ax88796b.ko) does NOT work for this board. :(
Don
--- In "Rekcut_Nod" <> wrote:
>
> Has anyone been able to get this board to work with a 2.6 kernel? The only
> TS documentation for this board simply says that 2.6 drivers are available.
>
> http://www.embeddedarm.com/about/resource.php?item=365
>
> However, using their driver, I am unable to actually USE the ports on the
> board (even though their interface comes up).
>
> I attempted the following with a 2.6.21-ts kernel:
> [1] Set the jumpers on the TS-ETH2 for 0x300 IRQ6 and 0x340 IRQ7
> [2] modprobe -o ts-eth2-1 ax88796b iobase=0x11e00000 mem=0x300 irq=33
> modprobe -o ts-eth2-2 ax88796b iobase=0x11e00000 mem=0x340 irq=40
> (the base address may be different, depending upon your main board. I used a
> TS-72xx board)
> [3] ifconfig eth1 192.168.0.11 netmask 255.255.255.0 up
> ifconfig eth2 192.168.0.12 netmask 255.255.255.0 up
> [4] connect port1 and port2 on the TS-ETH2 with a cross-over cable
> [5] ping -I eth1 192.168.0.12
>
> I actually tried to ping a separate machine (192.168.0.9) from eth1
> using the cross-over cable, but the result of either procedure was the
> same, "error occurred! Drop this packet!!" upon connection, and "From
> 192.168.0.11 icmp_seq=1 Destination Host Unreachable" after pinging.
>
> Don
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|