OK, Technologic System's initial response was due to a misunderstanding. I was
actually loading the driver incorrectly. Kris had mentioned earlier to specify
the iobase parameter with the insmod command, but you MUST NOT specify it with
the modprobe command or it sets both the 8-bit and 16-bit bases to the same
address. The correct way to load the driver for the TS-7260 is:
modprobe -o ts-eth2-1 ax88796b mem=0x300 irq=33
modprobe -o ts-eth2-2 ax88796b mem=0x340 irq=40
Don
--- In "Rekcut_Nod" <> wrote:
>
> FYI, Technologic Systems confirmed this morning that their 2.6 kernel driver
> (ax88796b.ko) does NOT work for this board. :(
>
> Don
> --- In "Rekcut_Nod" <dtucker@> wrote:
> >
> > Has anyone been able to get this board to work with a 2.6 kernel? The only
> > TS documentation for this board simply says that 2.6 drivers are available.
> >
> > http://www.embeddedarm.com/about/resource.php?item=365
> >
> > However, using their driver, I am unable to actually USE the ports on the
> > board (even though their interface comes up).
> >
> > I attempted the following with a 2.6.21-ts kernel:
> > [1] Set the jumpers on the TS-ETH2 for 0x300 IRQ6 and 0x340 IRQ7
> > [2] modprobe -o ts-eth2-1 ax88796b iobase=0x11e00000 mem=0x300 irq=33
> > modprobe -o ts-eth2-2 ax88796b iobase=0x11e00000 mem=0x340 irq=40
> > (the base address may be different, depending upon your main board. I used
> > a TS-72xx board)
> > [3] ifconfig eth1 192.168.0.11 netmask 255.255.255.0 up
> > ifconfig eth2 192.168.0.12 netmask 255.255.255.0 up
> > [4] connect port1 and port2 on the TS-ETH2 with a cross-over cable
> > [5] ping -I eth1 192.168.0.12
> >
> > I actually tried to ping a separate machine (192.168.0.9) from eth1
> > using the cross-over cable, but the result of either procedure was the
> > same, "error occurred! Drop this packet!!" upon connection, and "From
> > 192.168.0.11 icmp_seq=1 Destination Host Unreachable" after pinging.
> >
> > Don
> >
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|