Thanks, but EARLY_UART2 is already set in my configuration . The only place
EARLY_UART seems to be used is in the decompressor which is putting out its
messages successfully. Grepping in my kernel doesnât show any other place that
the EARLY_UART configuration is used. It is right after the decompressor
finishes and jumps to the actual kernel that output gets garbled.
CONFIG_MACH_TS72XX=y
# CONFIG_EP93XX_EARLY_UART1 is not set
CONFIG_EP93XX_EARLY_UART2=y
# CONFIG_EP93XX_EARLY_UART3 is not set
CONFIG_MACH_TS72XX_FORCE_MACHINEID=y
CONFIG_MACH_TS72XX_SBCINFO=y
Thanks,
Bill.
-----Original Message-----
From: On Behalf Of
Petr Åtetiar
Sent: Sunday, December 26, 2010 2:06 PM
To:
Cc:
Subject: Re: [ts-7000] Mangled baud rate on TS7200 2.6.34 console on ttyAM1 in
early init stages
William C. Landolina <> [2010-12-24 22:28:29]:
> Using Matthieuâs patches Iâve built a TS7200 2.6.34 kernel. When I
> select
> ttyAM0 as the console all is well. If I select ttyAM1, output is
> corrupted (probably wrong baud rate) between the âbooting kernelâ
> message from the decompressor and the âconsole [portname] enabledâ
> message. (Sample output
> below)
Hi,
take a look at CONFIG_EP93XX_EARLY_UART{1,2,3} kernel config options.
-- ynezz
------------------------------------
Yahoo! Groups Links
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|