Re: [ts-7000] Re: Not enough stable clock after synchronizing with ntp server.

[Dave Cramer <>]

On Wed, Aug 25, 2010 at 4:06 PM, palito.farias <> wrote:

 

Dave,
I run
ntpclient -i 300 -c 288 -h $NTPHOST > filename.log

i is the interval 300 seconds - 5 min, c the count 288 equivalent 24h and then your ntphost address. The log will then have a column for day, seconds, ntp transaction time. internal delay, clock difference and dispersion from server. All this is in the how to, where there also are gnu plot commands to obtain plots but I prefer to use matlab, just a personal preference. hope it helps.

Well, not quite what I was looking for. When you do finally get two devices synchronized how do you plan on taking simultaneous measurements ? Or is that a requirement ?

Dave

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___