Yes, its a 7350 (that was a typo). Kernel is the stock 2.6.21-ts kernel. The
board and the CAN card were ordered together, and the FPGA should have been
configured for PC-104 functionality.
--- In Joel Morgan <> wrote:
>
> On 3/3/10, sanjuan34 <> wrote:
> > I've tried it with nothing connected, and I've tried with with an Atmel
> > AT90CAN128 connected. I'm running a CAN monitor program on the Atmel, and
> > I'm also looking at CAN_H and I see zero activity.
> >
> > --- In Joel Morgan <jrcowboy79@> wrote:
> >>
> >> On 3/2/10, sanjuan34 <jdosher@> wrote:
> >> > Hi. I'm trying to get CAN bus working using a TS-CAN1 on a 7530 board.
>
> Is this a 7350?
> What kernel are you running?
>
> >> > I'm
> >> > loading the kernel module with out any errors using the following
> >> > parameters
> >> >
> >> > insmod -f lincan.ko io=0x150 hw=tscan irq=33
> >> >
> >> > (for IRQ6, JP4 on, I/O address 150, JP1 and JP2 off)
> >> >
> >> > I can run lincan utilities like sendburst, sendcan, readcan with out
> >> > error;
> >> > however, I'm getting no activity on CAN_H and CAN_L. All I see when
> >> > looking
> >> > at either line is a very odd looking 60Hz signal, about 2Vp-p. The
> >> > signal is
> >> > persistent whether the kernel module is loaded or not.
> >>
> >> What other CAN nodes do you have connected?
>
>
>
> --
> Joel R. Morgan
> Morgan Millwright Services, Inc.
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|