Re: [ts-7000] Re: TS7200 and non-standard baud rates

[Steve Weigold <>]

Fred wrote:

--- In .com, Steve Weigold <..> wrote:
> non-standard baud rate. Some searching has yielded
> suggestions of setting the rate to 38400 in termios
> and then using "setserial" to actually tweak the rate
> directly. Does this work on the 7200.

It works just fine. On the TS7250 I get 128,000 baud when I do this:

if (TRUE == for_half_duplex)
{
system("setserial /dev/tts/0 irq 22 uart 16550A skip_test baud_base 1662500 spd_cust divisor 12");

running_at_this_baud = B38400;
}

Thanks Fred!  I've checked out the man page for set serial and I think I know how to proceed from here.  I'm looking forward to trying it on the hardware when I get into the shop.  I appreciate the speedy response!

Steve

__._,_.___

Your email settings: Individual Email|Traditional
Change settings via the Web (Yahoo! ID required)
Change settings via email: =Email Delivery: Digest | m("yahoogroups.com?subject","ts-7000-fullfeatured");=Change Delivery Format: Fully Featured">Switch to Fully Featured
Visit Your Group | Yahoo! Groups Terms of Use | =Unsubscribe

__,_._,___