Hi,
We have just started working in the TS-RF2-Xbee Pro that we purchased
along with TS-7250.
We were able to get the drivers going.
Reading the messages in the forum I learn that we can send msgs to the
zigbee serial port by using the following command on TS-7250 command
prompt
echo "+++" > /dev/ttyTS0 # enter the command mode
I tried to issue a few commands like
echo "ATDL <CR>" > /dev/ttyTS0
and then tried to read the response using
cat /dev/ttyTS0
How ever I am not getting any output for the above command, could
someone explain to me what could be the reason.Is there any other
way to issue commands /read Xbee configuration
Thanks
Mohit Khanna.
--- In "Gonzalo A. de la Vega"
<> wrote:
>
> On Tue, Dec 23, 2008 at 11:27 AM, Fabio Ardeola <> wrote:
> > Hi
> > Does anyone know the default TS-RF2-ZIGBEE configuration? I mean,
> > network identifier,
>
> PAN ID: 0x3332 (acording to the manual)
>
> > node identifier and
>
> none = 0
>
> > destination node identifier.
>
> all = 0xFFFF
>
> I think you should be able to check this with AT commands.
>
> Gonzalo
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|