You can install and use the picocom terminal emulation program to access your
Zigbee module.
to install picocom
# apt-get install picocom
to access your Zigbee module
# picocom /dev/ttyTS0 9600
Regards,
Fabio
----- Original Message ----
From: mohit.khanna <>
To:
Sent: Wednesday, January 28, 2009 12:14:16 AM
Subject: [ts-7000] Re: TS-RF2-ZIGBEE
Hi
I am new to using TS-RF2-ZIGBEE with TS-7250 board, I have setup the
drivers I think, the blue light on xbee board does glow when I send
some something on the serial port eg. echo "data" \dev\ttyTS0
Can anyone tell me how to read the output of AT commands.
I tried the following but didnt get any output.
echo "+++" \dev\ttyTS0
echo "ATDL" \dev\ttyTS0
cat \dev\ttyTS0
I want to enter the command mode and change some settings of xbee.
Thanks
Mohit Khanna
Can anyone
--- In "Gonzalo A. de la Vega"
<> wrote:
>
> On Tue, Dec 23, 2008 at 11:27 AM, Fabio Ardeola <> wrote:
> > Hi
> > Does anyone know the default TS-RF2-ZIGBEE configuration? I mean,
> > network identifier,
>
> PAN ID: 0x3332 (acording to the manual)
>
> > node identifier and
>
> none = 0
>
> > destination node identifier.
>
> all = 0xFFFF
>
> I think you should be able to check this with AT commands.
>
> Gonzalo
>
------------------------------------
Yahoo! Groups Links
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/ts-7000/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/ts-7000/join
(Yahoo! ID required)
<*> To change settings via email:
<*> To unsubscribe from this group, send an email to:
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
|