Re: [ts-7000] Can jp6 of TS7200 be used as R/W ? Can I use jp5 for reading a externel bit data

[Michael Schmidt <>]

u2001149 wrote:
> In the spaecification sheet of TS7200, the address of jp6 is given as 
> 0x2280 0000.
> 
> I can read from it using the usual mmap(...) but when I try to write to 
> it as *dat=0 or 1 ... nothing the signals on the pin remain same.

Were you expecting the jumper to be ejected or magnetically attracted 
back onto the post? :-)

> The other jumpers jp2-jp5 are mentioned as RO (Read Only) while nothing 
> is mentioned about jp6 (user jumper).

They are all read-only.


> Regards

  ______   Best Regards,
|__  __/                  Michael Schmidt
    ||                   Software Engineer
    ||echnologic Systems (EmbeddedARM.com)
    || (480)    16610 East Laser Drive #10
    |/ 837-5200   Fountain Hills, AZ 85268
        http://oz.embeddedarm.com/~michael

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/ts-7000/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/ts-7000/join
    (Yahoo! ID required)

<*> To change settings via email:
     
    

<*> To unsubscribe from this group, send an email to:
    

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/